If an axial force of 1 kN is applied to a steel rod of 100 mm2 cross section area, the stress in it will be ___ .

Related MCQs

• A steel bar ABC (E = 200 GPa) is 1 m long. For AB = 0.7 m, it has cross section P area of 500 mm2 and for BC = 0.3 m the cross section area is 400 mm2. The bar is subjected to an axial pull of 100 kN. The stress is maximum in ___ _
• A stepped bar of steel consists of a pmormtion with cross section area 500 mm2 connected to a portion with cross section area 1000 2. Each portion has a length of 1 m. The modulus of elasticity of steel is 200 GPa. The maximum elongation of the bar by applying an axial tensile force at the ends without exceeding a stress of 100 MPa is    mm.
• If an axial force of 1 kN is applied to a rod of 100 mm2 cross section area, length 5 m and the modulus of elasticity of the material is 100 GPa, the change in length of the rod will be ___ .
• The change in length of a rod of uniform cross section was found to be 2 mm for some applied force. The change in length of a rod of the same material and length but of twice the cross section area subjected to the same force will be__ mm.
• A steel rod of cross sectional area equal to 1000 mm2 is 5 m long. If a pull of 100 kN is suddenly applied to it, then the maximum stress intensity will be
• The longitudinal stress developed in a rod of cross section area 50 mm2 is 100 MPa. The force acting along its axis is -------
• A prismatic steel bar 25 cm long is subjected to axial compressive force of 2000 kg. For steel E = 2 x 106 kg/cm2. The ratio of strain energy when the cross-sectional area is 25 sq. cm to that when the cross-section area is 12.5 sq cm, would be
• If an axial force of 1 kN is applied to a rod of 100 mm cross section area produces change in length of 1 mm over a length of 12 m, the modulus of elasticity of the material will be---------
• A copper rod 15 mm diameter 0.8 m long is heated through 50?C. The expansion of the rod is prevented by gripping it at both ends. When the grips do not yield, the stress in rod is 115 N/mm2 and forces applied at the grips are 20 kN. In case one of the grip yields by 0.5 mm
• If an axial force of 15 kN is applied to a rod of 25 mm diameter, length 300 mm, the change in length of the rod was observed to be 0.045 mm. The modulus of elasticity of the material is 200 GPa. The strain in the rod will be ____ _.