- Computer Science Engineering (CSE)
- Digital Electronics and Logic Design
- The CASE control structure is used when ...

Q. |
## The CASE control structure is used when an expression has a list of possible values. |

A. | true |

B. | false |

C. | none of the above |

D. | can not predict |

Answer» A. true |

View all MCQs in:
Digital Electronics and Logic Design

- Match List I with List II and select the correct answer form the codes given below the list List I A. A shift register can be B. A multiplexer C. A decoder can List II 1.for parallel to serial conversion 2.to generate memory can be used chip select 3.for parallel to serial conversion CODES: A B C
- When decisions demand two possible actions, the IF/THEN/ELSE control structure is used.
- When decisions demand one of many possible actions, the ELSIF control structure is used.
- A Karnaugh map is similar to a truth table because it presents all the possible values of input variables and the resulting output of each value.
- A J-K flip-flop has two control inputs. What happens to the Q output on the active edge of the clock if both control inputs are asserted simultaneously?
- A standard SOP form has terms that have all the variables in the domain of the expression.
- If a logic gates has four inputs, then total number of possible input combinations is
- If a logic gates has four inputs, then total number of possible input combinations is
- Why are the maximum value of VOL and the minimum value of VOH used to determine the noise margin rather than the typical values for these parameters?
- The simplification of the Boolean expression (A'BC')'+ (AB'C)' is

Login to Continue

It will take less than 2 minutes

Report MCQ