A thin cylinder contains fluid at a pressure of 30 kg kg/cm2, the internal diameter of the shell is 60 cm and the tensile stress in the material is to be limited to 900 kg/cm2. The shell must have a minimum wall thickness of

Related MCQs

• A boiler shell 280 cm diameter and plate thickness 12 mm is subjected to an internal pressure of 1.2 MN/m2. The hoop stress will be
• What should be the thickness of a cast iron pipe 45 cm diameter if it is required to sustain 6 kg/sq cm inside pressure ? The maximum stress in the pipe material being limited to 140 kg/cm2
• A compressed air cylinder carries approximately 70 kg/cm2 pressure at the time of delivery. The inside diameter is 25 cm. If the steel has a yield point of 2300 kg/sq cm and a safety factor of 2.5 the wall thickness should be
• In a central heating system, the seamless copper tubing used has an inside diameter of 20 mm and a wall thickness of 0.6 mm. For a maximum pressure of 1750 Kpa, when allowable stress is 225 Mpa, the safety factor will be
• A spherical metal vessel 120 cm diameter is subjected to an internal pressure of 15 kg/sq cm. If the permissible stress is 625 kg/sq cm and the efficiency of the riveted joints is 75%, the required thickness of the plate would be
• A spherical gas tank is made of 1 cm steel plate hemispheres but welded together. The tank is 1503 cm in diameter. The allowable internal pressure to which tank may be subjected is the permissible stress be limited to 840 kg/sq cm would be in the range
• In a gas turbine rotor a radial stress of 300 kg/sq cm tensile and 500 kg/sq cm tangential stress have been found at a point. The maximum shear stress at this point would be
• A 3 mm diameter rivet must be squeezed to form a head. When yield stress in tension for this alloy is 125 Kpa, the minimum value of initiating force must be not less than
• Two plates are joined by a parallel fillet welds. The plates are subjected to a tensile load of 35000 kg. If the allowable shear stress for the weld material be 800 kg the minimum length of 15 mm weld required to resist this load would be
• In case of biaxial stress system when a member is subjected to tensile stresses in two perpendicular directions the maximum shear stress in case of mild steel occurs on a plane inclined at