In case of biaxial stress system when a member is subjected to tensile stresses in two perpendicular directions the maximum shear stress in case of mild steel occurs on a plane inclined at

Related MCQs

• In a gas turbine rotor a radial stress of 300 kg/sq cm tensile and 500 kg/sq cm tangential stress have been found at a point. The maximum shear stress at this point would be
• If a machine member is loaded in such a way that the three principal stresses at a point are 600 kg/cm2 tension, 800 kg/cm2 compression and zero. The maximum shear stress at the point will be
• Two plates are joined by a parallel fillet welds. The plates are subjected to a tensile load of 35000 kg. If the allowable shear stress for the weld material be 800 kg the minimum length of 15 mm weld required to resist this load would be
• The ratio of maximum shear stress to average shear stress for a circular section is
• If machine number is loaded in such a way that the three principla stresses at a point are 600 kg/cm2 compression. 800 kg/cm2 tension and zero. The maximum shear stress at the point will be
• Neglecting bending, for a parallel load on a fillet weld of equal legs the plane of maximum shear occurs at
• For a parallel load on a fillet weld of equal leg the plane of maximum shear occurs
• For a transverse load on a fillet weld of equal legs, the plane of maximum shear force occurs at
• In the case of a cantilever, irrespective of the type, loading of the maximum bending moment and maximum shear force occur at
• A section is subjected to reversal of stresses. Choice exists for selecting any of the following section. Which one should be selected?