The pin supporting the exhaust iever of an internal combustion engine is subjected to a shear load of 400 kg/sq-cm the diameter of the pin should be

Related MCQs

• The piston of a internal combustion engine is subjected to
• Two plates are joined by a parallel fillet welds. The plates are subjected to a tensile load of 35000 kg. If the allowable shear stress for the weld material be 800 kg the minimum length of 15 mm weld required to resist this load would be
• A boiler shell 280 cm diameter and plate thickness 12 mm is subjected to an internal pressure of 1.2 MN/m2. The hoop stress will be
• A spherical metal vessel 120 cm diameter is subjected to an internal pressure of 15 kg/sq cm. If the permissible stress is 625 kg/sq cm and the efficiency of the riveted joints is 75%, the required thickness of the plate would be
• A spherical gas tank is made of 1 cm steel plate hemispheres but welded together. The tank is 1503 cm in diameter. The allowable internal pressure to which tank may be subjected is the permissible stress be limited to 840 kg/sq cm would be in the range
• The frictional horse power loss in a bearing having 25 mm diameter subjected to a load of 200 kg rotating at 600 rpm will be of the order of
• A cantilever beam of square section is subjected to a load W at the free end. If the length of the beam is increased and load reduced to half the deflection at the free end as compared to original deflection would be
• In case of biaxial stress system when a member is subjected to tensile stresses in two perpendicular directions the maximum shear stress in case of mild steel occurs on a plane inclined at
• The ratio of maximum shear stress to average shear stress for a circular section is
• The minor-diameter cross-section of the portion of the screw between the nut and the thrust bearing is subjected to