When large number of components are turned and parted off from a bar, the chuck used is

Related MCQs

• For aluminum casting to be turned on a lathe, which chuck would be preferred?
• While machining a brass casting on a lathe, the type of chuck used is
• A 30 mm diameter is being machined when the chuck is revolving at 100 rpm. The cutting speed is nearly
• While using high speed steel tools on lathe the speed of chuck will be lowest while machining
• In a sine bar the standard length is measured from
• The diameter of a round bar with close tolerances is quickly measured by
• When small castings are to be produced in large numbers, the type of pattern generally used is
• Electronic components are often joined by
• It is desired to remove large quantity of material from a job in shortest possible time, on a lathe using high speed steel cutter. Which of the following step will be helpful?
• Large size bolt heads are made by