A 30 mm diameter is being machined when the chuck is revolving at 100 rpm. The cutting speed is nearly

Related MCQs

• A work piece of 100 mm diameter is to be machined at a cutting speed of 100 metres per minute. The rpm of the work piece should be
• At what rpm should a lathe be run to give a cutting speed of 25 m/min. When turning a rod of diameter 32 mm.
• While using high speed steel tools on lathe the speed of chuck will be lowest while machining
• In a machining operation on free cutting mild steel the cutting speed is mentioned as 70 m/min. What should be material of cutting tool
• When 50 mm rod is turning at a spindle speed of 200 rpm the cutting speed would be
• For simple turning operation of lathe, the cutting speed is specified as 70 metres per minute. The cutting tool may be expected to be
• In a lathe gear box if first four consecutive speed are 19, 30, 47, 74 rpm, the next speed would be
• When large number of components are turned and parted off from a bar, the chuck used is
• For aluminum casting to be turned on a lathe, which chuck would be preferred?
• While machining a brass casting on a lathe, the type of chuck used is