A work piece of 100 mm diameter is to be machined at a cutting speed of 100 metres per minute. The rpm of the work piece should be

Related MCQs

• A 30 mm diameter is being machined when the chuck is revolving at 100 rpm. The cutting speed is nearly
• For simple turning operation of lathe, the cutting speed is specified as 70 metres per minute. The cutting tool may be expected to be
• At what rpm should a lathe be run to give a cutting speed of 25 m/min. When turning a rod of diameter 32 mm.
• In a machining operation on free cutting mild steel the cutting speed is mentioned as 70 m/min. What should be material of cutting tool
• When 50 mm rod is turning at a spindle speed of 200 rpm the cutting speed would be
• In a lathe gear box if first four consecutive speed are 19, 30, 47, 74 rpm, the next speed would be
• For cutting mild steel the cutting angle of a chisel should be
• While using high speed steel tools, the cutting speed will be highest for which of the following steel?
• Spindle speed in a lathe for turning a 40 cm dia rod at a cutting speed of 30 m/min would be
• The averge cutting speed for machining mild steel by high speed steel tool is