Unsymmetrical bending is said to occur when

Related MCQs

• The bending moment at a section tends to bend or deflect the beam and the internal stresses resist its bending. The resistance offered by the internal stresses, to the bending, is called
• In a simple bending theory, one of the assumption is that the plane sections before bending remain plane after bending. This assumption means that.
• In the simple bending theory one of the assumptions usually made is that the plane sections before bending remain plane after bending. This assumption implies that
• A prismatic beam fixed at both ends carries a uniformly distributed load. The ratio of bending moment at the supports to the bending moment at mid-span is
• A shaft of diameter D is subjected to a twisting moment (T) and a bending moment (M). If the maximum bending stress is equal to maximum shear stress developed, then M is equal to
• The bending moment diagram for a cantilever beam subjected to bending moment at the end of the beam would be
• If two unequal rolling loads of unequal weight roll along a beam, the maximum bending moment will occur
• For a beam of length L fixed at one end, supported at the other and loaded W at the centre C the maximum bending moment with occur at
• For a beam of length L fixed at end A and simply supported at end B and loaded uniformly by a load W the maximum bending moment will occur at
• A portion of a beam between two sections is said to be in pure bending when there is