If two unequal rolling loads of unequal weight roll along a beam, the maximum bending moment will occur

Related MCQs

• The bending moment diagram for a cantilever beam subjected to bending moment at the end of the beam would be
• A shaft of diameter D is subjected to a twisting moment (T) and a bending moment (M). If the maximum bending stress is equal to maximum shear stress developed, then M is equal to
• The bending moment at a section tends to bend or deflect the beam and the internal stresses resist its bending. The resistance offered by the internal stresses, to the bending, is called
• A prismatic beam fixed at both ends carries a uniformly distributed load. The ratio of bending moment at the supports to the bending moment at mid-span is
• A rectangular beam 200 mm deep by 100 mm wide-subjected to maximum bending moment of 500 kNm. The maximum stress in the beam will be
• The ratio of the area under the bending moment diagram between any two points along a beam to the flexural rigidity EI gives the change to the following parameter between the two points
• For a beam of length L fixed at one end, supported at the other and loaded W at the centre C the maximum bending moment with occur at
• For a beam of length L fixed at end A and simply supported at end B and loaded uniformly by a load W the maximum bending moment will occur at
• The maximum bending moment for a simply supported beam with a gradually varying load from zero at both ends and w per metre at the centre, lies at the centre of a beam.
• When a cantilever beam is loaded with concentrated loads, the bending moment diagram will be a