The ratio of the area under the bending moment diagram between any two points along a beam to the flexural rigidity EI gives the change to the following parameter between the two points

Related MCQs

• The bending moment diagram for a cantilever beam subjected to bending moment at the end of the beam would be
• A prismatic beam fixed at both ends carries a uniformly distributed load. The ratio of bending moment at the supports to the bending moment at mid-span is
• The bending moment at a section tends to bend or deflect the beam and the internal stresses resist its bending. The resistance offered by the internal stresses, to the bending, is called
• When there is no increase or decrease in shear force between two points, it indicates that there is no change in the bending moment between these points.
• A shaft of diameter D is subjected to a twisting moment (T) and a bending moment (M). If the maximum bending stress is equal to maximum shear stress developed, then M is equal to
• If two unequal rolling loads of unequal weight roll along a beam, the maximum bending moment will occur
• When the shear force diagram between any two points is an inclined straight line, it indicates that there is a uniformly varying load between the two points
• Two beams of equal cross-sectional area are subjected to equal bending moment. If one beam has square cross-section and the other has circular section, then
• The bending moment diagram for a simply supported beam carrying a uniformly distributed load of w per unit length, will be
• The bending moment diagram for a cantilever beam loaded with uniformly distributed load will be a parabolic curve.