In case of a beam subjected to pure bending

Related MCQs

• The bending moment diagram for a cantilever beam subjected to bending moment at the end of the beam would be
• The bending moment at a section tends to bend or deflect the beam and the internal stresses resist its bending. The resistance offered by the internal stresses, to the bending, is called
• A section of beam is said to be in pure bending, if it is subjected to
• In a beam subjected to pure bending, the intensity of stress in any fibre is
• A rectangular beam 200 mm deep by 100 mm wide-subjected to maximum bending moment of 500 kNm. The maximum stress in the beam will be
• A simply supported beam with rectangular cross-section is subjected to a central concentrated load. If the width and depth of the beam are doubled, then the deflection at the centre of the beam will be reduced to
• A cantilever beam carries a uniformly distributed load from fixed end to the centre of the beam in the first case and a uniformly distributed load of same inten¬sity from centre of the beam to the free end in the second case. The ratio of deflections in the two cases is
• In a simple bending theory, one of the assumption is that the plane sections before bending remain plane after bending. This assumption means that.
• In the simple bending theory one of the assumptions usually made is that the plane sections before bending remain plane after bending. This assumption implies that
• A prismatic bar when subjected to pure bending assumes the shape of