McqMate

Q. |
## How much percentage increase of permissible stress is allowed when dead load, live load and wind load are considered together in working stress method? |

A. | 50% |

B. | 33% |

C. | 40% |

D. | 60% |

Answer» B. 33% |

934

0

Do you find this helpful?

1

View all MCQs in

Design of Reinforced Cement Concrete ElementsNo comments yet

- In Working Stress Method, which of the following relation is correct?
- When ties are not provided the permissible values of the horizontal shear stress is?
- The end block of a prestressed concrete beam has a rectangular section; a cable carrying a force of 200kn is to be anchored against the end block at the centre if the cube strength of concrete at transfer is 30n/mm2. Design the maximum permissible bearing pressure?(Abr = 10000mm2)
- In the case of composite sections, the percentage of tensioned reinforcement is less than?
- If the surface is rough tamped and without links to withstand a horizontal shear stress of 0.6n/mm2 and assuming the moduli of elasticity of precast and insitu cast concrete to be equal the centroid of the composite section is located 110mm from the top of the slab, second moment area of composite section is 2487×105mm4, calculate ultimate shearing resistance?
- Which of the following is added to steel to increase resistance to corrosion?
- Design ultimate horizontal shear stress with nominal links and the contact surface are as cast (assume τ = 1.2n/mm2)?
- Which of the following is correct criteria to be considered while designing?
- What is Load Factor?
- Which of the following condition is true regarding the transfer of load from strap to soil, used in strap footing?