The end block of a prestressed concrete beam has a rectangular section; a cable carrying a force of 200kn is to be anchored against the end block at the centre if the cube strength of concrete at transfer is 30n/mm2. Design the maximum permissible bearing pressure?(Abr = 10000mm2)

Related MCQs

• The end block of a beam has a rectangular section 100mm wide by 200mm deep, the force of cable is 200kn. Find the actual bearing pressure?
• The minimum cube strength of concrete used for a prestressed member, is                  
• The proportioning of tendons in design of prestressed concrete simple flat slab between the column and middle strips may be based on                      
• The prestressed concrete slab systems are ideally suited for                      
• The ends of                  shall be properly anchored.
• The design of rigid rectangular combined footing consist in determining the
• The precast prestressed hollow core slabs, with or without topping is an important structural element in                      
• A simple prestressed flat slab is generally supported by a network of                      
• If the surface is rough tamped and without links to withstand a horizontal shear stress of 0.6n/mm2 and assuming the moduli of elasticity of precast and insitu cast concrete to be equal the centroid of the composite section is located 110mm from the top of the slab, second moment area of composite section is 2487×105mm4, calculate ultimate shearing resistance?
• In conventional design, allowable bearing capacity should be taken smaller than which of the following value?