For the design of gravity dam, the minimum value of F(factor of safety) against sliding should be                      

Related MCQs

• Which of the following is not one of the criteria, for design of gravity dam?
• In conventional design, allowable bearing capacity should be taken smaller than which of the following value?
• If a hammer is raised by steam and allowed to fall by gravity on top of the pile, it is called as                 
• The observed value of N in static cone penetration test is corrected by                    
• In which of the following rule, the value of each pile is reduced by one-sixteenth?
• The separation of Q at any stage of loading into Rp and Rf in cyclic test is based on experimental value found out by                 
• The inside clearance of the sampler should
• Explanation: For soft sensitive soil, the area ratio of sample should preferably not exceed 10%. The thin-wall samplers are those for
• According to Indian standard method, the loading of the plate should be borne with either by                        
• The allowable pressure, that should be selected for a maximum settlement is