There will be one point of discontinuity in the bending moment diagram of this question. State whether the above statement is true or false.

Related MCQs

• Consider the following statements: Sinking of an intermediate support of a continuous beam 1. Reduces the negative moment at support. 2. Increases the negative moment at support. 3. Reduces the positive moment at support. 4. Increases the positive moment at the centre of span. Of these statements
• Fabrication errors don’t cause additional stresses in statically indeterminate structures. State whether the above statement is true or false.
• The maximum negative bending moment in fixed beam carrying udl occurs at
• When a uniformly distributed load, longer than the span of the girder, moves from left to right, then the maximum bending moment at mid section of span occurs when the uniformly distributed load occupies
• When a uniformly distributed load, shorter than the span of the girder, moves from left to right,then the conditions for maximum bending moment at a section is that
• Bending moment at any section in a conjugate beam gives in the actual beam
• The maximum bending moment due to a train of wheel loads on a simply supported girder
• When a series of wheel loads crosses a simply supported girder, the maximum bending moment under any given wheel load occurs when
• In the slope deflection equations, the deformations are considered to be caused by (i) Bending moment (ii) Shear force (iii) Axial force The correct answer is
• A single rolling load of 8 kN rolls along a girder of 15 m span. The absolute maximum bending moment will be