The maximum negative bending moment in fixed beam carrying udl occurs at

Related MCQs

• Consider the following statements: Sinking of an intermediate support of a continuous beam 1. Reduces the negative moment at support. 2. Increases the negative moment at support. 3. Reduces the positive moment at support. 4. Increases the positive moment at the centre of span. Of these statements
• A fixed beam of the uniform section is carrying a point load at the centre, if the moment of inertia of the middle half portion is reduced to half its previous value, then the fixed end moments will              
• Bending moment at any section in a conjugate beam gives in the actual beam
• When a uniformly distributed load, longer than the span of the girder, moves from left to right, then the maximum bending moment at mid section of span occurs when the uniformly distributed load occupies
• When a series of wheel loads crosses a simply supported girder, the maximum bending moment under any given wheel load occurs when
• There are two beams of equal length L and a load P is acting on centre of both beams. One of them is simply supported at both ends while the other one is fixed at both ends. Deflection of centre of simply supported beam will be                      times that of defection of centre of fixed beam.
• Carryover Moment at end B due to moment M applied at end A for the given non-prismatic beam is                  
• When a uniformly distributed load, shorter than the span of the girder, moves from left to right,then the conditions for maximum bending moment at a section is that
• The maximum bending moment due to a train of wheel loads on a simply supported girder
• A single rolling load of 8 kN rolls along a girder of 15 m span. The absolute maximum bending moment will be