Determine the length of kennedy key required to transmit 1200N-m and allowable shear in the key is 40N/mm². The diameter of shaft and width of key can be taken as 40mm and 10mm respectively.

Related MCQs

• A force 2P is acting on the double transverse fillet weld. Leg of weld is h and length l. Determine the shear stress in a plane inclined at θ with horizontal.
• Calculate vertical prestressing force if wires of 5mm diameter with an initial stress of 1000n/mm2 are available for circumferential winding and Freyssinet cables made up of 12 wires of 8mm diameter stressed to 1200n/mm2 are to be used for vertical prestressing?
• Calculate the spacing of 5mm wires having a loss ratio of 0.075, compressive stress is 10.75n/mm2, 5mm diameter wires stress is 1000n/mm2, 12 wires of 8mm diameter are stressed to 1200n/mm2(Nd = 840n/mm2)?
• Maximum shear stress in transverse fillet weld of leg h and length l is
• Woodruff key permits            movement b/w shaft and the hub.
• Simple connections are used to transmit
• One way slabs may be supported across the entire width of the slab by means of
• What will be the width of metalled surface single lane on Major District road?
• An                    culvert is normally a low profile culvert. It allows them to be installed without disturbing the causeway as it will span over the entire drainage width.
• For initial estimate for a beam design, the width is assumed?