[Solved] Examine follwing two statements & choosethe correct relationship i) for a steam power plant Rankine cycle is preferred over Carnot cycle ii) a pump which will handle the mixture of vapour & liquid is difficult to construct

Q.	Examine follwing two statements & choosethe correct relationship i) for a steam power plant Rankine cycle is preferred over Carnot cycle ii) a pump which will handle the mixture of vapour & liquid is difficult to construct
A.	both i) ii) are correct & i) is the consequence of ii)
B.	both i) & ii) are independently correct
C.	i) is correct but ii) is not
D.	ii) is correct but i) is not
Answer» A. both i) ii) are correct & i) is the consequence of ii)

766

Do you find this helpful?

View all MCQs in

Engineering Thermodynamics

Discussion

No comments yet

Related MCQs

A steam power plant working on Rankine cycle produces steam in the boiler at a rate of 100 kg/s with enthalpy of 3280 kJ/kg from water whose total heat content is 420 kJ/kg. The plant has Rankine efficiency of 24.65 while pump requires 5 kJ/kg of work. The turbine generates power of
Correlate the following statements i) the volume of water into which steam is condensed in condenser is very much smaller than the volume of steam before condensation ii) the net work of a Rankine cycle is heat supplied in boiler - heat rejected to condenser - pump work
Consider the following statements regarding superheating in Rankine Cycles 1. It reduces the specific steam consumption 2. It increases the dryness fraction of steam at the exhaust for the same value of condenser pressure 3. It reduces the cycle efficiency Of the these statements
2 STATEMENTS OF SECOND LAW AND ITS COROLLARIES. CARNOT CYCLE REVERSED CARNOT CYCLE, PERFORMANCE. CLAUSIUS INEQUALITY.
In a simple Rankine cycle steam was expanded from 100 bar & 380°C to 1 bar 0.8 dry state. The pump motor consumes 10 kJ/kg of energy. The efficiency of cycle is
Considerfollowing options for a simple Rankine cycle i) increasing pressure at exist of turbine ii) increasing average temperature of heat addition iii) decreasing pressure at exit of turbine iv) superheating of steam v) decreasing pressure during superheating. Which combination of above will increase Rankine efficiency?
In a reheat Rankine cycle steam with enthalpy of 3300 kJ/kg is expanded in h.p turbine to a state where enthalpy is 2650 kJ/kg. The steam is further expnaded from a state where enthalpy is 2950 kJ/kg to enthalpy of 2525 kJ/kg & latent heat of 2201 kJ.kg. The work of the cycle & amount of reheat respectively are
The temperature of feed water can be increased in following two ways in a regenerative Rankine cycle i) by passing feed water around turbine casing in direction opposite to flow of steam ii) by bleeding certain portion of steam at the end of h.p expansion & mixing with condensate to make feed water at the temperature of boiler
Rankine cycle efficiency of a good steam power plant may be in the range of
Rankine cycle efficiency of a good Steam Power Plant may be in the range of?