McqMate

Q. |
## Find the gate voltage for voltage divider having R1=R2=1KΩ and VDD=5V? |

A. | 1v |

B. | 5v |

C. | 3v |

D. | 2.5v |

Answer» D. 2.5v | |

Explanation: vg = r2×vdd/r1+r2 |

2.2k

0

Do you find this helpful?

12

View all MCQs in

Electronic Circuits 1No comments yet

- Find the gate to source voltage for voltage divider having R1=R2=2KΩ and VDD=12V, ID=1mA and RS=4KΩ?
- What is the current flowing through the R1 resistor for voltage divider (R1=R2=1KΩ, VDD=10V)?
- If source resistance in an amplifier circuit is zero, then voltage gain (output to input voltage ratio) and source voltage gain (output to source voltage ratio) are the same.
- If peak voltage for a half wave rectifier circuit is 5V and diode cut in voltage is 0.7, then peak inverse voltage on diode will be?
- If the peak voltage on a centre tapped full wave rectifier circuit is 5V and diode cut in voltage is 0.7. The peak inverse voltage on diode is
- Consider an RC coupled amplifier at low frequency. Internal voltage gain is -120. Find the voltage gain magnitude, when given that collector resistance = 1kΩ, load = 9kΩ, collector capacitance is 0. is 0.1μF, and input frequency is 20Hz.
- Which of the following equation brings the relation between gate to source voltage and drain current in Self Bias?
- For a fixed bias circuit having RC=2Kohm and VCC=60V, IB=0.25mA and S=101, find Vce.
- Consider a voltage amplifier having a frequency response of the low-pass STC type with a dc gain of 60 dB and a 3-dB frequency of 1000 Hz. Then the gain db at
- Find net voltage gain, given hfe = 50 and hie = 1kΩ.