McqMate

Q. |
## What is the current flowing through the R1 resistor for voltage divider (R1=R2=1KΩ, VDD=10V)? |

A. | 5ma |

B. | 3ma |

C. | 1ma |

D. | 2ma |

Answer» A. 5ma | |

Explanation: ir1=ir2 =vdd/r1+r2 |

1.6k

0

Do you find this helpful?

9

View all MCQs in

Electronic Circuits 1No comments yet

- Find the gate voltage for voltage divider having R1=R2=1KΩ and VDD=5V?
- Find the gate to source voltage for voltage divider having R1=R2=2KΩ and VDD=12V, ID=1mA and RS=4KΩ?
- If source resistance in an amplifier circuit is zero, then voltage gain (output to input voltage ratio) and source voltage gain (output to source voltage ratio) are the same.
- In CB configuration, the value of α=0.98A. A voltage drop of 4.9V is obtained across the resistor of 5KΩ when connected in collector circuit. Find the base current.
- Obtain the collector voltage, for collector resistor (RC) =5.6kΩ, IE=1.664mA and VCC=10v for single input unbalanced output differential amplifier
- If peak voltage for a half wave rectifier circuit is 5V and diode cut in voltage is 0.7, then peak inverse voltage on diode will be?
- If the peak voltage on a centre tapped full wave rectifier circuit is 5V and diode cut in voltage is 0.7. The peak inverse voltage on diode is
- A transistor has hie =2kΩ, hoe=25µmhos and hfe=60 with an unbypassed emitter resistor Re=1kΩ. What will be the input resistance and output resistance?
- A transistor has hie =1KΩ and hfe=60 with an bypassed emitter resistor Re=1kΩ. What will be the input resistance and output resistance?
- A Differential Amplifier should have collector resistor’s value (RC1 & RC2) as