Calculate the work done per minute by a punch tool making 20 working strokes per min when a 30 mm diametre hole is punched in 5 mm thick plate with ultimate shear strength og 450 Mpa in each stroke.

Related MCQs

• A machine punching 38 mm holes in 32 mm thick plate requires 7 N-m of energy per sq. mm of sheared area, find the maximum shear force required.
• 4 strokes engine have a lower thermal efficiency than 2 stroke engine.
• The relation between stroke punch s and radius of crank r is              
• If the stroke punch is 100mm, find the radius of the crank in mm.
• In a slider crank mechanism, the length of the crank and connecting rod are 180 mm and 540 mm respectively. The crank position is 45° from inner dead centre. The crank shaft speed is 450 r.p.m. (clockwise), calculate angular velocity of the connecting rod in rad/s.
• 4-stroke engine has one power stroke per 2 revolutions hence turning moment diagram is uniform.
• In the turning moment diagram of a multicylinder engine, the work done during exhaust stroke is by              
• Which of the following process is not the part of working of a 4 stroke I.C Engine?
• Work produced by the 4-stroke engine is less because                
• It is required to lift water at the top of a high building at the rate of 50 litres/min. Assuming the losses due to friction equivalent to 5 m and those due to leakage equal to 5 m head of water, efficiency of pump 90%, decide the kilowatt capacity of motor required to drive the pump.