While machining insulating ceramic materials using EDM, where is the sheet metal placed?

Related MCQs

• State whether the following statement is true or false about material removal in EDM. “In EDM, high pressures allow the metal to evaporate.”
• What are the surface roughness values obtained while machining spherical surfaces using Electro discharge machining?
• During wire cut EDM, the size of the cavity produced by the wire while machining depends upon            
• What are the tolerance values obtained by machining using EDM?
• State whether the following statement is true or false regarding EDM. “In EDM, process is affected by hardness of material.”
• State whether the following statement is true or false regarding wear in EDM. “In EDM, electrode wear is less dominant when it comes to micromachining applications.”
• State whether the following statement is true or false regarding wear in EDM. “In EDM, corner wear ratio does not depend on type of electrode material.”
• State whether the following statement is true or false regarding the dielectric in EDM. “In EDM, flushing through the tool is more preferred than side flushing.”
• State whether the following statement is true or false regarding the HAZ in EDM. “In EDM, post treatment to recover fatigue strength is not recommended.”
• The only difference between die-sink EDM and wire cut EDM is the