If the gap thickness is greater than equilibrium thickness what will be MRR?

Related MCQs

• At constant gap thickness material removal becomes equal to feed rate. What is this gap called?
• In WJM, what are the properties of jet fluid that affect the MRR?
• In the following properties of nozzle, which of them does not influence the MRR?
• Which of the following are the features of tool affecting MRR in USM?
• What happens to MRR with increase in tool amplitude?
• If there is an increase in viscosity of slurry, what happens to MRR?
• As the tool area increases, what happens to MRR?
• When the static pressure of the feed is increases, what happens to MRR?
• On which of the following components, does the MRR depend?
• What happens to the surface roughness values if the MRR increases in EDM?