The cost of additional control hardware remain a                    fraction of total machining cost.

Related MCQs

• For large components, actual machining time constitutes to how much percentage of the total machining time?
• Which of the following is not a part of machining system of Water jet machining?
• What are the uses of catcher in machining system of Water jet machining?
• In Water jet machining, tool need not require sharpening once the machining is done.
• In machining system of AJM, which is the medium of carrying the abrasive grains for machining?
• State whether the following statement is true or false, about Abrasive jet machining. “Using Abrasive jet machining, micro deburring of hypodermic needles can take place.”
• When compared to the conventional machining, how much times faster, is the Abrasive water jet machining?
• Conicity resulting after machining by Ultrasonic Machining can be reduced by?
• Which of the following electrodes are used for machining spherical surfaces in Electro discharge machining?
• What are the surface roughness values obtained while machining spherical surfaces using Electro discharge machining?