The                    are provided in expansion and contraction joints to transfer the load.

Related MCQs

• The expansion and contraction joints generally consist of some elastic material, known as                  which should be compressible, rigid, cellular and Resilient.
• Heat transfer and work transfer are
• A 2 m2 window has a surface temperature of 15°C and the outside wind is blowing air at 2°C across it with a convection heat transfer coefficient of h = 125 W/m2K. What is the total heat transfer loss?
• What is the general value for coefficient of contraction?
• The black grille on the back of a refrigerator has a surface temperature of 35°C with a surface area of 1 m2. Heat transfer to the room air at 20°C takes place with convective heat transfer coefficient of 15 W/Km^2. How much energy is removed during 15 minutes of operation?
• 2 THERMAL EXPANSION OF SOLIDS AND LIQUIDS
•                is commonly used in liquid- expansion thermometers.
• Liquid expansion thermometers are filled with                  
• A water-heater is covered with insulation boards over a total surface area of 3 m2. The inside board surface is at 75°C and the outside being at 20°C and the conductivity of material being 0.08 W/m K. Find the thickness of board to limit the heat transfer loss to 200 W ?
• A large heat exchanger transfers a total of 100 MW. Assume the wall separating steam and seawater is 4 mm of steel, conductivity 15 W/m K and that a maximum of 5°C difference between the two fluids is allowed. Find the required minimum area for the heat transfer.