The use of tie plates in laced columns is

Related MCQs

• When two plates are placed end to end and are joined by two cover plates, the joint is known as
• The side thrust T on the tie rods provided at the end beam of jack arch of rise R, is calculated from the formula
• The strength of ISA 125 = 75 × 10 mm used as a tie member with its longer leg connected at the ends by 27 mm diameter rivets, is
• Maximum permissible slenderness ratio of a member normally acting as a tie in a roof truss, is
• The side thrust T on the tie rods provided at the end beam of jack arch of rise R, is calculated from the formula
• The strength of ISA 125 = 75 × 10 mm used as a tie member with its longer leg connected at the ends by 27 mm diameter rivets, is
• Maximum permissible slenderness ratio of a member normally acting as a tie in a roof truss, is
• Rivets connecting flange angles to cover plates in a plate girder are subjected to
• When plates are exposed to weather, tacking rivets are provided at a pitch in line not exceeding (where t is the thickness of the outside plate).
• The area Ap of cover plates in one flange of a built up beam, is given by