Maximum permissible slenderness ratio of a member normally acting as a tie in a roof truss, is

Related Questions

• Maximum permissible slenderness ratio of a member normally acting as a tie in a roof truss, is
• To minimize the total cost of a roof truss, the ratio of the cost of truss to the cost of purlins shall be
• To minimize the total cost of a roof truss, the ratio of the cost of truss to the cost of purlins shall be
• The maximum permissible slenderness ratio of a member carrying loads resulting from wind, is
• The maximum permissible slenderness ratio of compression member carrying dead and superimposed load, is
• The maximum permissible slenderness ratio of compression member carrying dead and superimposed load, is
• Normally, the angle of roof truss with asbestos sheets should not be less than
• A tension member, if subjected to possible reversal of stress due to wind, the slenderness ratio of the member should not exceed
• A tension member, if subjected to possible reversal of stress due to wind, the slenderness ratio of the member should not exceed
• The maximum slenderness ratio of a compression member carrying both dead and superimposed load is