A DC motor runs at 1725rpm at full load and 1775rpm at no load. The speed regulation is _____.

Related MCQs

• A 4 pole, 500V shunt motor has 720 wave connected conductors on its armature. The full load armature current is 60A and flux per pole is 0.03Wb. The armature resistance is 0.2Ω and contact drop per brush is 1V. What is the full load speed of the motor?
• The DC motor, which can provide zero speed regulation at full load without any controller is
• A 4-pole, 3-phase induction motor is running at 4 percent slip at full load. If the speed of the motor is 720 rpm, the supply frequency is
• A 3 phase induction motor running with full load slip of 1.2% and its rotor impedance per phase on standstill is 0.016+j0.265Ω then the ratio of full load torque to maximum torque is
• A 3 phase induction motor connected from a 3 pjhase, 50Hz AC supply runs at 720rpm and has slip 4%. The number of poles in motor are _____.
• A 440V, 20HP, 3phase motor operates at full load, 88% efficiency and 0.65 power factor lagging, the current drawn by motor is
• A shunt motor runs at 500rpm on a 200V circuit. Its armature resistance is 0.5Ω and the current taken is 30A in addition to field current. What resistance must be placed in series with armature circuit to reduce to speed to 300 rpm; the current in armature remains same.
• A 200V DC series motor runs at 500rpm when taking a line current of 25A.The resistance of the armature is 0.3Ω and that of the series field is 0.5Ω. If current taken remains constant, calculate the resistance necessary to reduce the speed to 350rpm.
• A 6pole, 3-ph induction motor is runs at a speed of 960rpm & the shaft torque is 135.7Nm. Calculate the rotor cu loss if the friction and windage losses amount to 150W. The suppy freq is 50Hz.
• A 4 pole, 50Hz induction motor runs at a speed of 1440rpm. The frequency of the rotor induced emf is _____.