In the figure shown below, which of the following type of runners has the blade curvature as shown in the above figure (The arrow denotes direction of blade motion)?

Related MCQs

• In which of the following type of runners the velocity of whirl at inlet is greater than the blade velocity?
• In which of the following type of runners in a Kaplan turbine the velocity of whirl at inlet is smaller than the blade velocity?
• In the velocity diagrams for Francis turbine, which of the following velocity directions is along the blade curvature?
• The component of the total force exerted by fluid on a body in the direction parallel to the direction of motion is called as
• In the figure shown below,which of the following angles replace the question mark?
• If the elevation of hydraulic grade line at the junction of three pipes is above the elevation of reservoirs B and C and below reservoir A, then the direction of flow will be
• IN what type of turbine water enters in radial direction and leaves axial direction?
• A closed tank containing water is moving in a horizontal direction along a straight line at a constant speed. The tank also contains a steel ball and a bubble of air. If the tank is decelerated horizontally, then i) the ball will move to the front ii) the bubble will move to the front iii) the ball will move to the rear iv) the bubble will move to the rear Find out which of the above statements are correct ?
• For the figure given below, find the missing terms in the order of (1), (2), (3) and (4).
• The discharge through a wholly drowned orifice is given by (where H1 = Height of water (on the upstream side) above the top of the orifice, H2 = Height of water (on the downstream side) above the bottom of the orifice, and H = Difference between two water levels on either side of the orifice)