Keeping the mass moment of inertia of both the shafts in a two rotor system same, if the length of one shaft is doubled what should be the effect on the length of other shaft?

Related MCQs

• For a two rotor system, the mass moment of inertia of one shaft(A) is twice the other(B), then what is the relation between the length of the shafts.
• A single cylinder oil engine works with a three rotor system, the shaft length is 2.5m and 70mm in diameter, the middle rotor is at a distance 1.5m from one end. Calculate the free torsional vibration frequency for a two node system in Hz if the mass moment of inertia of rotors in Kg-m2 are: 0.15, 0.3 and 0.09. C=84 kN/mm2
• A single cylinder oil engine works with a three rotor system, the shaft length is 2.5m and 70mm in diameter, the middle rotor is at a distance 1.5m from one end. Calculate the free torsional vibration frequency for a single node system in Hz if the mass moment of inertia of rotors in Kg-m2 are: 0.15, 0.3 and 0.09. C=84 kN/mm2
• In a gearing system, pump speed is one third of the motor. Shaft from motor is 6 cm in diameter and 30cm long, the impellar shaft is 10cm diameter and 60cm long. Mass moment of inertia is 1500 Kgm2, C = 80Gn/m2. Neglecting the inertia of shaft and gears calculate the frequency of free torsional vibrations in Hz.
• The mass moment of inertia of the two motors in a two rotor system are 100 kgm2 and 10 kgm2 the length of the shaft of uniform
• Two rotors A and B are connected to the two ends of a shaft of uniform diameter. The mass moment of inertia of rotor A about the
• Consider the following statements: Two rotors mounted on a single shaft can be considered to be equivalent to a geared-shaft system having two rotors provided 1. The kinetic energy of the equivalent system is equal to that of the original system. 2. The strain energy of the equivalent system is equal to that of the original system. 3. The shaft diameters of the two systems are equal. Which of these statements are correct?
• In a three rotor system, for the middle rotor, if the stiffness of both the length either side of the rotor is increased to two times what will
• In the diagram shown below, if rotor X and rotor Z rotate in same direction and rotor Y rotates in opposite direction, then specify the type of node vibration.
• For a vibration system having different shaft parameters, calculate which of the following cannot be the diameter of the equivalent shaft if the diameters of shafts in m are: 0.05, 0.06, 0.07.