The technique or method to absorb undesirable sounds by soft and porous

Related MCQs

• Soft materials absorb a large amount of
• Temperature monitoring technique uses which of the following devices to measure temperature of the machining surfaces?
• According to which method, maximum kinetic energy at mean position is equal to maximum potential energy at extreme position?
• In a gearing system, pump speed is one third of the motor. Shaft from motor is 6 cm in diameter and 30cm long, the impellar shaft is 10cm diameter and 60cm long. Mass moment of inertia is 1500 Kgm2, C = 80Gn/m2. Neglecting the inertia of shaft and gears calculate the frequency of free torsional vibrations in Hz.
• In the diagram shown below, if rotor X and rotor Z rotate in same direction and rotor Y rotates in opposite direction, then specify the type of node vibration.
• A single cylinder oil engine works with a three rotor system, the shaft length is 2.5m and 70mm in diameter, the middle rotor is at a distance 1.5m from one end. Calculate the free torsional vibration frequency for a single node system in Hz if the mass moment of inertia of rotors in Kg-m2 are: 0.15, 0.3 and 0.09. C=84 kN/mm2
• A single cylinder oil engine works with a three rotor system, the shaft length is 2.5m and 70mm in diameter, the middle rotor is at a distance 1.5m from one end. Calculate the free torsional vibration frequency for a two node system in Hz if the mass moment of inertia of rotors in Kg-m2 are: 0.15, 0.3 and 0.09. C=84 kN/mm2
• Let the disturbing mass be 100 kg and the radius of rotation be 10 cm and the rotation speed be 50 rad/s, then calculate the centrifugal force in kN.
• A V-twin engine has the cylinder axes at 90 degrees and the connecting rods operate a common crank. The reciprocating mass per cylinder is 11.5 kg and the crank radius is 7.5 cm. The length of the connecting rod is 0.3 m. If the engine is rotating at the speed is 500 r.p.m. What is the value of maximum resultant secondary force in Newtons?
• Let the centrifugal force in kN be 25 and the radius of rotation be 20 cm and the rotation speed be 50 rad/s, then calculate the mass defect in Kg.