[Solved] Reducing the armature voltage will give us

McqMate

Q.	Reducing the armature voltage will give us
A.	variable torque speed control
B.	constant torque speed control
C.	variable and constant both can be achieved
D.	cannot comment on torque
Answer» B. constant torque speed control
Explanation: as seen from speed torque characteristics, reducing armature voltage

2.5k

0

Do you find this helpful?

12

View all MCQs in

Electrical Drives and Controls (EDC)

Discussion

No comments yet

Related MCQs

In the rotor voltage injection method, when an external voltage source is in phase with the main voltage then speed will
In the rotor voltage injection method, when an external voltage source is in opposite phase with the main voltage then speed will
Reducing the field current will give us
To implement armature voltage control, it must be ensured that
an external voltage source is in phase with the main voltage then speed will
A 6-pole lap wound DC generator has a developed power of P watts and brush voltage of E volts. Three adjacent brushes of the machine had been found worn out and got open circuited. If the machine is operated with the remaining brushes, voltage and power that could be obtained from the machine are
motor. The maximum allowable current is 55 A and the minimum current is about 35 A. The armature resistance of the motor is 0.4 Ω. What will be the number of sections of starter resistance required?
A 100 hp, 250 V, 350 A shunt dc motor with an armature resistance of 0.05 ohms. To limit maximum starting current to twice the rated of its value, what will be the number of stages of starting resistances?
The direct-on-line starter is used to start a small dc motor because it limits initial current drawn by armature circuit.
full load efficiency of 85% has armature resistance of 0.25 ohms. Calculate the value of starting resistance in ohms for a current 1.5 times of the full load current.