Three solid objects of the same material and of equal mass-a sphere, a cylinder (length = diameter) and a cube are at 500°C initially. These are dropped in a quenching bath containing a large volume of cooling oil each attaining the bath temperature eventually. The time required for 90% change in temperature is the smallest for

Related MCQs

• A steel sphere of radius 0.1 m at 400°K is immersed in an oil at 300°K. If the centre of the sphere reaches 350°K in 20 minutes, how long will it take for a 0.05 m radius steel sphere to reach the same temperature (at the centre) under identical conditions? Assume that the conductive heat transfer co-efficient is infinitely large.
• A hollow sphere and a solid sphere of the same material and equal radii are heated to the same temperature. In this case,
• A sphere of radius 'R1' is enclosed in a sphere of radius 'R2'. The view (or shape) factor for radiative heat transfer of the outer sphere with respect to the inner sphere is
• A shpere, a cube and a disc all of the same material, quality and volume are heated to 900K and left in air. Which of these will have the lowest rate of cooling
• The coefficient of linear expansion of a solid is L. The volume V of a cube of this solid on being heated by 1?C will change by
• Two rods one of copper and the other of mild steel, both of diameter 20 mm and length 250 mm are coated with a uniform layer of wax all around. These rods are placed vertically in a boiling water bath with 200 mm, length of each rod projecting outside. If the melting point of wax is 10?C, then
• A cube, sphere & a thin circular plate (all having same mass and made of same material) are all heated to 300°C and allowed to cool in natural air. Which one will cool the slowest?
• A long iron rod initially at a temperature of 20°C has one end dipped in boiling water (100°C) at time, t = 0. The curved surface of the rod is insulated so that heat conduction is one dimensional in the axial direction. The temperature at a distance 100 mm from the dipped end becomes 40°C at time, t = 200 s. The same temperature is achieved at a distance of 200 mm from the dipped end at time
• In a laboratory test run, the rate of drying was found to be 0.5 x 10-3 kg/m2 .s, when the moisture content reduced from 0.4 to 0.1 on dry basis. The critical moisture content of the material is 0.08 on a dry basis. A tray dryer is used to dry 100 kg (dry basis) of the same material under identical conditions. The surface area of the material is 0.04 m2 /kg of dry solid. The time required (in seconds) to reduce the moisture content of the solids from 0.3 to 0.2 (dry basis) is
• 200 kg of solids (on dry basis) is subjected to a drying process for a period of 5000 seconds. The drying occurs in the constant rate period with the drying rate as, Nc = 0.5 × 10-3 kg/m2 .s. The initial moisture content of the solid is 0.2 kg moisture/kg dry solid. The interfacial area available for drying is 4 m2 /1000 kg of dry solid. The moisture content at the end of the drying period is (in kg moisture/kg dry solid).