Two rods one of copper and the other of mild steel, both of diameter 20 mm and length 250 mm are coated with a uniform layer of wax all around. These rods are placed vertically in a boiling water bath with 200 mm, length of each rod projecting outside. If the melting point of wax is 10?C, then

Related MCQs

• A long iron rod initially at a temperature of 20°C has one end dipped in boiling water (100°C) at time, t = 0. The curved surface of the rod is insulated so that heat conduction is one dimensional in the axial direction. The temperature at a distance 100 mm from the dipped end becomes 40°C at time, t = 200 s. The same temperature is achieved at a distance of 200 mm from the dipped end at time
• Three rods one made of glass, one of pure aluminium and one made of wrought iron are heated to 150?C. All the rods are 15 mm in diameter and 300 mm long. The lowest temperature at the free end of the rods will occur in case of
• Three solid objects of the same material and of equal mass-a sphere, a cylinder (length = diameter) and a cube are at 500°C initially. These are dropped in a quenching bath containing a large volume of cooling oil each attaining the bath temperature eventually. The time required for 90% change in temperature is the smallest for
• Boiling point elevation for a strong and concentrated solution is found by Duhring's rule, which states that at the same pressure, the boiling point of a solution is a linear function of the __________ of pure water.
• A composite flat wall of a furnace is made of two materials 'A' and 'B'. The thermal conductivity of 'A' is twice of that of material 'B', while the thickness of layer of 'A' is half that of B. If the temperature at the two sides of the wall are 400 and 1200°K, then the temperature drop (in °K) across the layer of material 'A' is
• A sphere 15 cm in diameter is covered with 5 cm of insulation (k = 0.057 kcal/m-hr-?C). The inside and outside surface temperature of the insulation are 315?C and 80?C respectively. The heat loss per sq. m of the outside surface will be closer to
• In case of __________ boiling, the liquid temperature is below the saturation temperature and the boiling takes place in the vicinity of the heated surface.
• Boiling of milk in an open vessel is an example of __________ boiling.
• A liquid to liquid counterflow heat exchanger is used to heat cold fluid from 50?C to 150?C. Assuming that the hot fluid enters at 250?C and leaves at 200?C, the log mean temperature difference for the heat exchanger will be closer to
• Boiling point of a solution according to Duhring's rule is a linear function of the __________ of water.