Which of the following is the most controlling factor for the rate of bubble detachment from the hot solid surface?

Related MCQs

• 200 kg of solids (on dry basis) is subjected to a drying process for a period of 5000 seconds. The drying occurs in the constant rate period with the drying rate as, Nc = 0.5 × 10-3 kg/m2 .s. The initial moisture content of the solid is 0.2 kg moisture/kg dry solid. The interfacial area available for drying is 4 m2 /1000 kg of dry solid. The moisture content at the end of the drying period is (in kg moisture/kg dry solid).
• The rate of energy emission from unit surface area through unit solid angle, along a normal to the surface, is known as
• The rate of heat flow between a solid wall and a fluid (in contact with a solid wall) is given by
• The rate of radiant energy, which is emitted by a surface at any temperature and in small wavelength is found from the known rate of energy, which under the same condition would be emitted from a black surface by multiplying with the absorptivity. Above enunciation is known as
• For a given ambient air temperature with increase in the thickness of insulation of a hot cylindrical pipe, the rate of heat loss from the surface would
• Two bodies one hot and the other cold are kept in vacuum. What will happen to the temperature of the hot body after sometime?
• In a laboratory test run, the rate of drying was found to be 0.5 x 10-3 kg/m2 .s, when the moisture content reduced from 0.4 to 0.1 on dry basis. The critical moisture content of the material is 0.08 on a dry basis. A tray dryer is used to dry 100 kg (dry basis) of the same material under identical conditions. The surface area of the material is 0.04 m2 /kg of dry solid. The time required (in seconds) to reduce the moisture content of the solids from 0.3 to 0.2 (dry basis) is
• A hot body will radiate heat most rapidly, if its surface is
• The coefficient of linear expansion of a solid is L. The volume V of a cube of this solid on being heated by 1?C will change by
• Fouling factor for a heat exchanger is given by (where, U1 = heat transfer co-efficient of dirty surface U2 = heat transfer co-efficient of clean surface).