Among casting, forging and forging which has the slowest rate of production?

Related MCQs

• While designing a forging, the profile is selected such that the fibrous lines are parallel to the tensile forces and perpendicular to shear forces.
• In forging, metal is in which of the following stage?
• Among gas and electric arc welding, which has the higher rate of heating?
• What is the amount of sea coal needed in cast irons for large green casting moulding sands?
• What is the amount of sea coal needed in cast irons for small casting moulding sands?
• Among punching and drilling, which is cheaper?
• Among punching and drilling, punching is safer.
• A curved beam has neutral axis is curved while loaded and straight when unloaded.
• A curved beam with eccentricity 0.02D is loaded with 1kN.Centroidal radius=4D and inner and outer radii are 3.5D and 4.5D respectively. Area of cross section is 0.8D². Find the dimension D if allowable stress is 110N/mm² and considering only direct tensile stress.
• If bending moment on point B in horizontal plate is M and in vertical plane is m, then the net bending moment at point B is? "The layout of a shaft supported on bearings at A & B is shown. Power is supplied by means of a vertical belt on pulley B which is then transmitted to pulley C carrying a horizontal belt. The angle of wrap is 180’ and coefficient of friction is 0.3. Maximum permissible tension in the rope is 3kN. The radius of pulley at B & C is 300mm and 150mm"