Among punching and drilling, punching is safer.

Related MCQs

• Among punching and drilling, which is cheaper?
• Among casting, forging and forging which has the slowest rate of production?
• Among gas and electric arc welding, which has the higher rate of heating?
• A curved beam with eccentricity 0.02D is loaded with 1kN.Centroidal radius=4D and inner and outer radii are 3.5D and 4.5D respectively. Area of cross section is 0.8D². Find the dimension D if allowable stress is 110N/mm² and considering only direct tensile stress.
• If bending moment on point B in horizontal plate is M and in vertical plane is m, then the net bending moment at point B is? "The layout of a shaft supported on bearings at A & B is shown. Power is supplied by means of a vertical belt on pulley B which is then transmitted to pulley C carrying a horizontal belt. The angle of wrap is 180’ and coefficient of friction is 0.3. Maximum permissible tension in the rope is 3kN. The radius of pulley at B & C is 300mm and 150mm"
• Determine the size of the bolts if yield strength of bolt is 400N/mm² and factor of safety is 4. The bolts are equidistant having separated by 60mm and the margin to the left and right is 25mm. Also P=5kN acts at a distance of 200mm from the channel.
• If allowable shear stress in the shaft is 70N/mm² and torsional and bending moments are M=1185000N-mm and m=330000N-mm, find the diameter of the shaft.
• Determine the length of kennedy key required to transmit 1200N-m and allowable shear in the key is 40N/mm². The diameter of shaft and width of key can be taken as 40mm and 10mm respectively.
• Determine the secondary shear stress acting on the bolt 3 and its direction. The bolts are equidistant having separated by 60mm and the margin to the left and right is 25mm.Also P=5kN acts at a distance of 200mm from the channel.
• 1816mm and radius of centroidal axis is 100mm, then find the bending stress at inner fibre whose radius is 50mm. Area of cross section of beam is 7200mm² and the beam is loaded with 100kN of load.