The amount by which the two rods to be joined are drawn together is called as?

Related MCQs

• Two steel rods connected by cotter joint are subjected to 50 kN load each. What is the minimum diameter required of the rods? (Given: Yielding Stress= 400N/mm² ; Factor of Safety=6)
• Cotter joint can be used to connect two rods for torque transmission purpose.
• Knuckle Joint can’t be used to connect two intersecting rods.
• If knuckle joint is to fail by crushing failure of pin in fork, then determine the diameter of knuckle pin when 50kN axial tensile force act on rods. Given: Max allowable compressive stress=25N/mm², thickness of each eye of fork=25mm.
• Refer to fig Two plates are fastened by means of two bolts. The yield strength of bolt is 400N/mm² and factor of safety is 4. Determine the size of the bolts.
• Refer to fig. Two plates are fastened by means of two bolts. The yield strength of bolt is 400N/mm² and factor of safety is 4. Determine the permissible shear stress in the bolts.
• For bonding action of clays, what is the amount of water needed?
• What is the amount of sea coal needed in cast irons for large green casting moulding sands?
• What is the amount of sea coal needed in cast irons for small casting moulding sands?
• A knuckle joint is unsuitable for two rotating shafts, which transmit torque