A water tolerance test would be performed on:

Related MCQs

• When adding water to a penetrant, the water tolerance limit is indicated when:
• When using a straight beam technique to examine a thick test piece what change(s) would you expect to see in back wall echo size as you approach the side of the test piece? (Transducer remains completely on test piece)
• While performing a fluorescent water washable penetrant test, which of the following steps should be performed under black light?
• A soft aluminium test piece is to be penetrant tested. The piece has previously been sand blasted to remove tightly adhering soils. What additional surface preparation should be performed?
• For adequate test results, the black light used in fluorescent penetrant examination should provide what minimum black light intensity at the test surface?
• When performing a post emulsifiable penetrant test, the test piece does not rinse acceptable clean during normal processing. What should be done?
• A 7.6 cm (3 inches) thick test specimen is radiographed with a source having size of 1.3 cm (1/2 inch), the film is placed in contact with the test specimen. The source to film distance is 40.6 cm (16 inches).The geometric unsharpness obtained is:
• An ultrasonic test using a straight beam contact search unit is being conducted through the thickness of a flat part such as a plate. This test should detect:
• Which type of developer would you use to obtain the highest sensitivity test results?
• Which of the following characteristics would be most important in a test piece which is to be tested using the residual method?