According to ASME Section VIII, a linear indication is defined as an indication in which the length is equal to or greater than the width by a factor of:

Related MCQs

• According to ASTM E709-95 and API, a linear indication is defined as an indication in which the length is equal to or greater than the width by a factor of:
• According to API, a non- relevant indication is defined as an indication which in the major dimension is equal to, or less than:
• A dark, jagged, linear indication appears on a radiograph of a casting. The area is a transition area between a thick and a thin section. This indication should be interpreted as:
• In a radiograph of a weld there is an indication appearing at the end of the weldbead. It appears as a dark rounded indication with fine small tails coming from around the rounded indication giving it some what of a star-shaped appearance. This would probably be:
• When a vertical indication has reached the maximum signal height which can be displayed or viewed on the CRT of an ultrasonic instrument, the indication is said to have reached its:
• A continuous linear indication along the centre of a fillet weld would most likely be a:
• A continuous linear indication along the edge of a new fillet weld would most likely be a:
• Flux density is a measure of the number of magnetic flux lines perpendicular to an area of cross-section. If a discontinuity is in the plane of the unit area, the strongest magnetic article indication will be formed when the discontinuity is:
• Sound waves of a frequency beyond the hearing range of the human ear are referred to as ultrasonic waves or vibrations, and the term embraces all vibrational waves of frequency greater than approximately:
• A dark, sharply defined, straight line in the centre of the weld, and running parallel with the length of the weld should be interpreted as: