According to API, a non- relevant indication is defined as an indication which in the major dimension is equal to, or less than:

Related MCQs

• According to ASTM E709-95 and API, a linear indication is defined as an indication in which the length is equal to or greater than the width by a factor of:
• According to ASME Section VIII, a linear indication is defined as an indication in which the length is equal to or greater than the width by a factor of:
• In a radiograph of a weld there is an indication appearing at the end of the weldbead. It appears as a dark rounded indication with fine small tails coming from around the rounded indication giving it some what of a star-shaped appearance. This would probably be:
• According to ASTM E709-95 and API, the UV intensity measured at a minimum of 38 cm (15 inches) at least shall not be less than:
• According to ASTM E709-95 and API, relevant indications are produced by:
• According to ASTM E709-95 and API, the thickness of non conductive coatings will not exceed:
• When a vertical indication has reached the maximum signal height which can be displayed or viewed on the CRT of an ultrasonic instrument, the indication is said to have reached its:
• A dark, jagged, linear indication appears on a radiograph of a casting. The area is a transition area between a thick and a thin section. This indication should be interpreted as:
• According to API, the acceptable particle concentration of wet particle solution for fluorescent particles is:
• According to API, the particle concentration of wet particle solution must be checked: