According to ASTM E709-95 and API, relevant indications are produced by:

Related MCQs

• According to ASTM E709-95 and API, the UV intensity measured at a minimum of 38 cm (15 inches) at least shall not be less than:
• According to ASTM E709-95 and API, the temperature of the dry particles can be usable up to:
• According to ASTM E709-95 and API, the thickness of non conductive coatings will not exceed:
• According to ASTM E709-95 and API, when fluorescent particles are used, the UV bulb shall warm up prior to use for at least:
• According to ASTM E709-95 and API, a linear indication is defined as an indication in which the length is equal to or greater than the width by a factor of:
• A group of indications, some sharp and some broad and fuzzy, were found on an area of a small forging. Demagnetization and re-inspection eliminated these indications. What was the probable cause?
• Fluorescent penetrant indications are more visible than colour contrast penetrant indications because:
• Dark rounded indications with rather smooth edges appear on the radiograph of casting made in sand mould. These indications would be interpreted as:
• According to API, a non- relevant indication is defined as an indication which in the major dimension is equal to, or less than:
• The causes of non relevant indications are: