According to ASTM E709-95 and API, the thickness of non conductive coatings will not exceed:

Related MCQs

• According to ASTM E709-95 and API, the UV intensity measured at a minimum of 38 cm (15 inches) at least shall not be less than:
• According to ASTM E709-95 and API, the temperature of the dry particles can be usable up to:
• According to ASTM E709-95 and API, relevant indications are produced by:
• According to ASTM E709-95 and API, when fluorescent particles are used, the UV bulb shall warm up prior to use for at least:
• According to ASTM E709-95 and API, a linear indication is defined as an indication in which the length is equal to or greater than the width by a factor of:
• According to ASTM E709-95 in using prod technique, prod spacing shall not exceed:
• According to ASTM E709-95 the viscosity limit (measured in centi Stokes) of the wet medium (conditioned water) should not exceed:
• According to ASTM E709-95 the alkalinity of conditioned water shall not exceed:
• According to AST M E709-95 and API, after removing magnetization of parts after examination, the residual magnetism shall not exceed (1 gauss = 0.0001 tesla):
• According to ASTM E709-95 in using prod technique on a 50 mm thickness plate with a prod spacing of 101 mm (4 inches), current shall be selected in the following range: