[Solved] The minimum size hole in an ASTM penetrameter is:

McqMate

Q.	The minimum size hole in an ASTM penetrameter is:
A.	0.127 mm (0.005inches)
B.	0.254 mm (0.010 inches)
C.	0.508 mm (0.020inches)
D.	0.762 mm (0.030 inches)
Answer» B. 0.254 mm (0.010 inches)

2.7k

0

Do you find this helpful?

21

View all MCQs in

Non Destructive Testing and Evaluation

Discussion

No comments yet

Related MCQs

The ASTM penetrameter for a 25 mm thick test piece contains holes of what sizes?
Natural discontinuities comparable in size to the penetrameter holes shown on a radiograph may not be detected because:
Another name for a penetrameter is:
The penetrameter is a tool used to check the of a radiograph:
The basic purpose of a penetrameter is to:
According to ASTM E709-95 and API, the UV intensity measured at a minimum of 38 cm (15 inches) at least shall not be less than:
In performing a water content test of a lipophilic emulsifier per ASTM D-95, what solvent is used?
Demagnetization, ASTM E709-95 recommends a coil of ampere-turns:
According to ASTM E709-95 when dry particles are used magnetic particle testing shall not be performed on the surface of parts whose temperature exceeds:
According to ASTM E709-95 in using prod technique, prod spacing shall not exceed: