[Solved] A calibration for immersion ultrasonic testing of pipe or tubing should establish a transducer position such as:

McqMate

Q.	A calibration for immersion ultrasonic testing of pipe or tubing should establish a transducer position such as:
A.	I.D. and O.D. notches produce equal responses for equivalent metal path distances
B.	Rayleigh waves are generated through the entire pipe or tubing wall
C.	All ultrasound enters the test piece
D.	Only longitudinal waves are generated in the test piece
Answer» C. All ultrasound enters the test piece

2k

0

Do you find this helpful?

5

View all MCQs in

Non Destructive Testing and Evaluation

Discussion

No comments yet

Related MCQs

During immersion ultrasonic testing of pipe or tubing, spurious echoes may be caused by:
During immersion testing of pipe or tubing the incident longitudinal wave angle must be limited to a narrow range. The reason for the upper limit is:
In immersion testing, the position of the search unit is often varied to transmit sound into the test part at various angles to the front surface. Such a procedure is referred to as:
During ultrasonic testing by the immersion method, it is frequently necessary to angulate the search unit when a discontinuity is located at an angle in order to:
An ultrasonic testing technique in which the transducer element is not parallel to the test surface is called:
A disadvantage of using a high frequency ultrasonic transducer is:
Which of the following transducer materials is the most efficient receiver of ultrasonic energy?
A A disadvantage of using a low frequency ultrasonic transducer is:
A A disadvantage of using a low frequency ultrasonic transducer is:
A A disadvantage of using a high frequency ultrasonic transducer is: