[Solved] In flow through pipe bends the pressures on inner and out radii

McqMate

Q.	In flow through pipe bends the pressures on inner and out radii
A.	Stand at the same level increasing gradually towards the pipe center.
B.	Vary, it being more on the inner core.
C.	Are different, pressure increases with increase in radius and is, therefore, more at the outer radius.
D.	Do not vary and are the same as at the center of the pipe.
Answer» D. Do not vary and are the same as at the center of the pipe.

793

0

Do you find this helpful?

4

View all MCQs in

Fluid Mechanics and Hydraulic Machines

Discussion

No comments yet

Related MCQs

The distance from pipe boundary, at which the point velocity is equal to average velocity in case of turbulent flow (when R is the radius of the pipe), is
2𝑔 148. The power transmitted through the pipe is maximum when head lost due to friction in the pipe is equal to
In case of turbulent flow of a fluid through a circular tube (as compared to the case of laminar flow at the same flow rate) the maximum velocity is ....., shear stress at the wall is ....., and the pressure drop across a given length is ....., the correct words for the blanks are, respectively
Flow in a pipe where average flow parameters are considered for analysis is an example of
For achieving continuous flow through a system, no position of the pipe should be higher than
When a fluid flows through a tapering pipe at a constantly increasing rate, the flow is said to
In laminar flow through a pipe, discharge varies
For a laminar flow through a pipe the shear stress over a cross-section
A U-tube manometer, attached to an air pipe, measures 20 cm of mercury. The pressure, in kPa, in the air pipe is
The velocity in a 2 cm-diameter pipe is 20 m/s. If the pipe enlarges to 5 cm diameter velocity, in m/s, will be