Head loss due to fitting in pipe.

Related MCQs

• A compound pipe line is made up of pipe 45 cm dia. for 900 m, 37.5 cm for 450 m and 30 cm for 300 m is required to replace by a pipe of uniform diameter. Find diameter of equivalent pipe.
• The diameters of a pipe at the sections 1 and 2 are 10 cm and15 cm respectively. Find the discharge through the pipe if the velocity of water flowing through the pipe at section 1 is 5 m/s.
• Sometimes a compound pipe is required to be replaced by a pipe of uniform diameter and of the same length as that of the compound pipe is known as
• Head loss due to bend in pipe.
• A simple manometer containing mercury is used to measure pressure of oil (sp. gr. 0.8) flowing in a pipe as shown below. Mercury level in open tube is 150 mm higher than that on left limb. If height of oil in left limb is 90 mm, determine the pressure in terms of head of water in a pipe.
• The diameters of a pipe at the sections 1 and 2 are 10 cm and15 cm respectively. The velocity of water flowing through the pipe at section 1 is 5 m/s. Determine the velocity at section 2.
• The velocity of liquid particles at the centre of pipe is less than the velocity of particles near the inner surface of pipe.
• If pressure heads (P/w) of a liquid Bowing in a pipe be plotted as vertical ordinates on the center line of the pipe, then the line joining the tops of such ordinates is known as
• If the sum of pressure heads and velocity heads [(p/w) + (v2 /2g)] of a liquid flowing In a pipe be plotted as vertical ordinates on the centre line of the pipe. then the line joining the tops of such ordinates is known as
• A pipe line is 6 km long and having 20 cm diameter connect two reservoir 'A' and 'B'. The rate of discharge in the pipe is 30 lit/sec. Find out the difference in reservoir levels if friction factor f = 0.0008.