While laying a pipeline we have to connect pipes of different lengths and diameters with one another to form a pipeline. Such a pipeline is called a

Related MCQs

• The diameters of a pipe at the sections 1 and 2 are 10 cm and15 cm respectively. Find the discharge through the pipe if the velocity of water flowing through the pipe at section 1 is 5 m/s.
• The diameters of a pipe at the sections 1 and 2 are 10 cm and15 cm respectively. The velocity of water flowing through the pipe at section 1 is 5 m/s. Determine the velocity at section 2.
• A pipe line is 6 km long and having 20 cm diameter connect two reservoir 'A' and 'B'. The rate of discharge in the pipe is 30 lit/sec. Find out the difference in reservoir levels if friction factor f = 0.0008.
• The Hagen William formula is used to design the pipeline.
• When body or matter flows from one point to another point on application of shear force, it is called
• Whenever a liquid (such as water, oil etc.) is filled in a vessel, it exerts force at all points on the sides and bottom of the container. This force per unit area is called
• ______ is defined as the property of a fluid which offers resistance to movement of one layer of fluid over another adjacent layer of the fluid.
• Attraction between the molecules of liquids to another body is called ___________.
• The imaginary line, drawn in the fluid E in such a way that the tangent to any point gives the direction of motion (velocity) at the point is called
• An inverted triangular plate is having base parallel to water surface with width 1.6 m and height 2.10 m. It is submerged in water in such a way that its base is 1.0 m below free surface. Find total pressure.