To design a cross-over between parallel tracks, the required components are:

Related MCQs

• If D is the distance between parallel tracks G between theoretical noses of two crossings measured parallel to tracks, is
• If D is distance between centres of two parallel tracks of gauge G with entire curved leads and equal angles of crossing, total length of crossover, is
• Which of the following devices is used to transfer the wagons or locomotives to and from parallel tracks without any necessity of shunting?
• In a scissors crossover, the crossings provided are (i) 2 obtuse angle crossings (ii) 4 obtuse angle crossings (iii) 4 acute angle crossings (iv) 6 acute angle crossings The correct answer is
• Heel divergency, the distance between the running faces of stock rail and gauge face of tongue rail, as recommended for Indian B.G. tracks, is
• The formation width for a railway track depends on the (i) Type of gauge (ii) Number of tracks to be laid side by side (iii) Slope of sides of embankment or cutting The correct answer is
• The grade compensation on B.G. tracks on Indian Railways, is
• The type of switch generally used for B.G. and M.G. tracks, is
• On B.G. tracks the distance of outer signal from station limit is kept
• The lengths of the standard crossings in India for Broad gauge and Metre gauge tracks is same for